I tried different paper today for the toner transfer method to make my own boards. This paper is quite a bit cheaper than the "blue" type. I've only done 1 board and it seems to work just as well. Need to do a couple more to make sure.
So I etched another Si5351 booster board, populated it with most of the components. I received my smt caps yesterday so I put them on the 2 boards. Modified the board layout to accommodate the pot I'm using so board 3 will represent the better board when I get around to it. Total of 3 boards are required for this project.
I had 6 xtals to use in the crystal filter. I did some measurements and here are the results:
xtal value
1 11,072.061
2 11,072.275
3 could not get a reading
4 11,071.969
5 11,072.254
6 11,072.202
Need to acquire several more to get the bet possible match.
No comments:
Post a Comment